Leading Manufacturers through Product Compliance - Our Slogan

Radio Equipment

radio_webRadio equipment that is being sold in the UK and Europe is required to be CE Marked under the Radio Equipment Directive (typically shortened to ‘RED’).

The new Radio Equipment Directive (2014/53/EU) will set out the new regulatory framework for radio equipment and it is intended to replace the old R&TTE Directive (1995/5/EC) from the 13th June 2016. There are a number of significant changes between the old and new, so it is important to be prepared in readiness for the change.

Scope

The Radio Equipment Directive applies to:

‘Radio Equipment’ defined as an electrical or electronic product, which intentionally emits and/or receives radio waves for the purpose of radio communication and/or radio-determination. The previous Directive also covered ‘Telecommunications Terminal Equipment’, but this is no longer the case under the new Directive (Such equipment will now fall into the scope of the EMC or Low Voltage Directives).

Note – The Directive also applies to products that only lack an accessory, such as an antenna, to perform the above function.

The Directive is also subject to some exclusions that are set out in Annex I:

  • Radio equipment used by amateurs, unless available commercially, within Article 1, definition 56, of the International Telecommunications Union (ITU) radio regulations;
  • Marine equipment within the scope of the Marine Equipment Directive;
  • Airborne products falling within the scope of the European Regulation for civil aviation products, parts and appliances;
  • Custom-built evaluation kits to be used purely for research and development purposes.

Conformity Requirements

The conformity requirements of the RED Directive are similar to the requirements of the old R&TTE Directive. Equipment should still provide electrical protection to meet the safety objectives of the Low Voltage Directive, and still meet the protection requirements of the EMC Directive.

However, now the conformity process now requires a manufacturer to undertake an ‘adequate analysis and assessment of the risk(s)’, commonly known as a Risk Assessment. The use of a risk assessment in CE marking has always been something has been beneficial to help manufacturers undertake and follow the conformity process, but the requirements within the Directive is now clear. The requirement to undertake a risk assessment is now a clear requirements across all of the new 2016 Directives.

The routes to conformity for radio equipment have slightly changed, and are found in Chapter II. The procedures are summarised below:


red-process

How we can help

The CE Marking Association can assist companies with the conformity assessments of their radio equipment and we have a range of services to meet your needs. We can undertake some or all of the tasks with our compliance services, or we can help bring the knowledge in-house with our training and consultancy services. Here are some of the services on offer:

  • Testing and assessments for conformity to the RE Directive.
  • In-company or public Radio Equipment Directive training
  • Consultancy advice and assessments on related Directives, such as Low Voltage and EMC
  • Undertake Risk Assessments and many more.

For more support on CE Marking under the Radio Equipment Directive, or to find out how we can help you, please call us on 01564 792349, or please complete our online enquiry form.

 
UKCA Support Services
Tel: 01564 792349
Email: info@ukcasupportservices.co.uk
-